How to measure - single roller door screens

This screen can be fitted in 2 ways. For each method of fixing we will show you:

• a visualisation drawing
• a how to measure drawing

Reveal fitted

Visualisation

How to measure

The cassette (51mm wide) is fitted into the top of the reveal and the floor using two tabs and screws - usually positioned on the same side as the door is hinged.  The closing channel (22mm wide) is fitted to the opposite reveal wall using screws.

The two guides (both 40mm high) are screwed into to the underside of the reveal and the floor.  For low thresholds, a 22mm bottom guide is available. as an option.

We advise taking 3 measurements for both width (top, middle & bottom) and height (left, middle & right) to allow for any variations. In each case use the smallest measurements for your final width and height. We will make your screen to these sizes.

Face fitted

Visualisation

How to measure

The cassette is fitted to the side door frame (usually positioned on the side the door is hinged) using brackets fitted to the side of the cassette.  The total width of the cassette + brackets is 66mm.

The top and bottom guides (both 40mm high) slot into the ends the cassette and are fitted to the upper and lower door frames.  For low thresholds, a 22mm bottom guide is available as an option.

The closing channel (22mm wide), is fitted directly to the door frame.on the opposite side of the door to the cassette.

We will make your screen with the maximum outer dimensions to be the measurements provided..